C Style Flex-Flex Couplings
The C Kind coupling consists of two flex hubs, 1 sleeve and one accessory kit consisting of seals and snap rings.
CFR Form Flex-Rigid Couplings
The CFR Type coupling include a single flex hub, one rigid hub, 1 sleeve, a single accessory kit consisting of seals and snap rings.
Easy and economical variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Obtainable as vertical and horizontal couplings
Broad assortment of particular variations for example full-flex, flex-rigid mill motor
Conventional configurations are available with the shelf
Ordering Details
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical and so forth.
Power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Kind Couplings
Ordering Facts
Puller Holes are normal on sizes four by twelve.
Puller Holes can be found for sizes 7/8 via three.five at an extra charge.
The BSE (distance Concerning Shaft Ends) might vary involving G and G1.
Interference bores without set screws are normal unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, talk to Engineering Section.
More substantial sizes can be found, please seek advice from Technical Assistance.