Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is created exclusively for your small lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit continues to be broadly utilised in the market of logistic products for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled from the solenoid valve together with the velocity managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Standard Description
This energy unit is built solely for the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the velocity controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is lower, the decreasing motion is controlled from the manual override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This energy unit is made solely for that massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as speed managed by a pressure compensated movement control valve.
Energy UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is made solely to the large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace managed by the adjustable needle valve. When the lift rises to a high positoin, but the electrical power provide is cut, the lowering motion is managed by the manual override function.
Distinctive Notes
one. This electrical power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes 
off.
two. Clean the many hydraulic components concerned ahead of set up of the electrical power unit.
three. Viscosity with the oil shoud be 15~46 cst,which need to also be clean and free of impurities.N46 hydraulic oil is encouraged.
4. Oil altering is needed immediately after the initial a hundred operation hrs,afterwards the moment every 3000 hrs.
five. The energy unit proven is designed to be mounted vertically.
